3770K da ide na 2.0v?
Ma 1.200 (jedan cijelih dva)
, pogrešno sam se otipkao. Nego, zanimljiva situacija, pustio sam Prime95 da odradi minimalnih 6 sati, sve OK, nema greške, procesor konstantno na 70-75°, napon 1.192 - 1.200, vetilator ne prelazi 1650RPMova. Sve pet.
Ugasim računalo, vratim se za četiri sata, upalim ga, ajd' čisto da vidim što će se desiti još jednom da kresnem Prime95 - isti tren blue screen of death.
Digao sam mu napon za +0.1, sad je na idle 1.288, a kad ga Prime95 uhvati, opet padne na 1.192. Jel' mu matična spušta napon da zadrži nisku temperaturu? Jel' to normalno ponašanje?
EDIT:
Također, nisam znao da 100% ne znači da procesor jednako naporno radi. Kad pustim nešto rendati, sve su jezgre na 100% (isto kao i Prime95), ali temperatura jedva da prelazi 60°, s tim da vetilator ne pređe 1200 okretaja. Djeluje kao da ga Mental ray bitno manje optereti nego Prime.
EDIT2:
Ahhh, i see...
vDroop - the difference between the idle and load voltage.. Generally, you get a higher voltage when idling than when at full load. That's because it works as a self-protection mechanism to prevent too much voltage surging into the chip and frying it, or not giving it enough power.
For example, if your chip needs can take a voltage range of 1.35v - 1.55v, you might find that your idle voltage is around 1.50v. When you put it under full load, it'd drop to 1.47v. That's vDroop.
The board gives it extra voltage at idle so that when the chip goes into full load it can handle the negative voltage drop without going below the minimum 1.35v.
Likewise, the voltage upshoot from from full load to idle is protected by vOffset. That's the difference between your idle voltage and the maximum the chip can handle. You might find that when switching from full load to idle the voltage goes over the 1.50v and then comes back down to settle at 1.50v. That's to give it some room up top away from the 1.55v maximum.
EDIT3:
Ma ovaj proces overklokanja je sav neki naopak
Kao prvo spustio sam voltažu s +0.1 na +0.08, i bilo mi je isključeno "C1E support" (u BIOSu, jel). Sad sam uključio i na idle voltaža ide skroz dolje 0.99nešto, ili 1.0nešto. A kad ga Prime95 testira viša je, ali opet niža nego kad je bilo na "Auto", 1.17nešto, 1.18nešto. Ni blizu 1.2. Sad mi nije jasno kako može biti stabilniji s nižom voltažom? Jeli to normalno? Temperatura je pod testiranjem ista 70-75°.
